Looking for some help.

[BJ]

I'm wanting to integrate my rear blinkers into the rear tail light. I know it's possible with the setup I have (dual brake bulbs). I have a buddy that can do it, but the problem is, he's in alabama for a while. There's no real rush, it's just something I'm wanting to do. If any of you know how to do this, and wouldn't mind helping, I would really appreciate it. I'm also looking for more R6 riders to compare bikes. Thanks guys :)

[dizzyg44]

It's not really hard and most of the stuff can be found at a regular auto parts store in the trailer accessories.

But the easiest way (not the cheapest but still not really expensive) is to check Cycle gear to see if they have a signal integrator in stock, most usually do.

I did this on the falco with a module (can't remember brand) from CG, only takes a few minutes to install and not hard at all.

to do it niice and clean be aware that you will probably need to cut wires.

If I remember correctly, this is the one I had
http://www.customdynamics.com/integrator_kit.htm


Look at this if you want to DIY
http://www.apriliaforum.com/forums/showthread.php?t=80456

Do keep in mind that this technically illegal as FVMSS requires like 16" of separation if I remember correctly

[BJ]

Thanks for the help! :D